So if you want to restore the stock firmware of Moto E3 [XT1706], then you came at right place today we are going to tell you how to restore the stock firmware of Moto E3 .I tell you how to unbrick a soft brick Moto E3 Power by installing stock rom.

Lenovo has recently launched all new Moto E3 the generation (2016)  In India.If you’re someone WHO likes to root each android phone, then you most likely knew that MotoE3  will be rooted currently however there continuously a risk of sentimental bricking whereas rooting or installing / Flashing recovery on the phone.But you’ll be able to get rid of that by flashing the stock ROM.

Download and Install Stock rom of Moto E3 Power and UnBrick it.

So if you have softbricked your Moto E3 and now you are feeling that Stock firmware was best for Moto E3 then yes you can now install stock firmware on Moto E3 Power we must be thankful to senior member of XDA dr.faramroze for creating the stock firmware files for moto E3. he really did a great job for all the Moto E3 users.
First of all you have to root and install TWRP recovery on your android mobile if you haven't done already. 

After you have successfully Rooted and installed TWRP recovery on Moto E3 then download the Stock firmware files from below.

Pre Requirements


1.    Backup your important apps , messages and contacts.
2.    Charge your mobile upto 80%.
3.    Do not try this installation guide on any other android device.
4.    Follow the above guide first before jumping to this one

Downloads :


How to install Stock Firmware on Moto E3 Power.

  • First of all download Moto E3 Stock firmware files from above.
  • Now unzip the zip files
  • Copy the zip files in your mobile SD card/internal memory.
  • Now boot your mobile into recovery mode by pressing and holding Volume up and power button at a same time.
  • Now in TWRP recovery your screen will look like this.
  • Now tap on wipe and do wipe data factory reset and wipe cache partition.
  • Now go back and tap on Install
  • Now select the zip file which you have copied in your mobile SD Card/Internal Memory.
  • Flash the file and wait until the installation got done.
  • Reboot your device after that.
  • Done !!
You have successfully installed TWRP recovery on your Moto E Power.
If you are facing any difficulty and issue then please comment below we love to hear from you.
Share To:
Magpress

MagPress

Vestibulum bibendum felis sit amet dolor auctor molestie. In dignissim eget nibh id dapibus. Fusce et suscipit orci. Aliquam sit amet urna lorem. Duis eu imperdiet nunc, non imperdiet libero.

1 comments so far,Add yours

  1. Error : Unable to fin META-INF/... in zip file while restoring zip in TWRP
    Please help

    ReplyDelete